How to Mount a Flush Valve

The flush valve, located in the middle of the commode tank, includes the overflow tube, the hole where water enters the dish when the bathroom is purged, and also the rubber container round or flapper that covers the hole when the tank is full. A broken flush valve prevents your toilet storage tank from forming a seal to hold water in the tank. If you hear your tank leaking, first try replacing the flapper. If that does not function, changing your flush valve will certainly help save water as well as maintain your commode operating properly. In this article, the flush valve supplier will show you how to replace the flush valve in three very simple steps.

1. Drain Pipes the Toilet Container

Switch off the water at the valve and drainpipe tank by flushing the commode.

Separate the water supply line with an adjustable wrench.

Loosen the tank screws utilizing a screwdriver and a flexible wrench.

2. Remove the Toilet Storage Tank

Eliminate the toilet container and also delicately position it inverted on an old towel or rug.

3. Replace Flush Valve

Loosen the spud nut with a spud wrench or a set of slip-joint pliers as well as remove the old flush valve.

Glide the cone washer onto the tailpiece of the new flush valve - the diagonal side of the cone washer should aim towards completion of the tailpiece.

Insert the flush valve into the tank opening so that the overflow pipe faces the fill valve.

4. Set up a Brand-New Flush Valve

Screw the spud nut back onto the tailpiece of the brand-new flush valve, tighten up with a spud wrench or a set of slip joint pliers, and also put the soft spud washer over the tailpiece.

5. Reinstall the Toilet Tank as well as Replace the Flapper

Re-install the commode tank and connect the water supply line.

Change the flapper and reconnect the refill tube to the top of the overflow tube.

Turn on the water as well as check for leaks.